System technical specifications

Compatible systems per frequency band: 4
Auto Setup Features: No
Audio Reference Companding: No
Included Antennas: Attached 1/4-wave
Antenna Options: No
PC Control: No
Receiver Network Ability: No
Rack Hardware: Optional (WASRM for 2 single channel receivers, WADRM for dual channel receiver)
Case: No
Transmitter Display: LED
Receiver Display: LED
Battery, Endurance: 2AA, >10h
Environment: Small stage, karaoke, hotels, schools, restaurants

Further Technical Specs

Working Range (Line of Sight)

HI power mode: 75 m (250 ft)
LO power mode: 18 m (60 ft)

Note: Actual range depends on RF signal absorption, reflection and interference.

Audio Frequency Response

50 Hz to 15 kHz

Note: Dependent on microphone type

Total Harmonic Distortion (Ref. ±48 kHz deviation, 1 kHz tone)

For J9 (New Zealand): Total Harmonic Distortion (Ref. ±26 kHz deviation, 1 kHz tone)

Dynamic Range

90 dB A-weighted, typical

Operating Temperature Range

–10°C (14°F) to 50°C (122°F)

The SVX1 Bodypack Transmitter can be used with the SVX Lavalier or Headworn Wireless system.

Tech Specs

Transmitter Type: Bodypack
Dimensions: 108 mm height X 64 mm width X 19 mm depth
RF Output Power: 10
Battery, endurance: 10 h
Weight: 90 g

CVL

Tech Specs

Transducer Type :Condenser
Polar Pattern: Cardioid
Frequency Response from: 50 Hz
Frequency Response to: 20 KHz
Sensitivity (dBV/Pa): -43.5 dBV/Pa
Weight: 25 g

Further Technical Specs

Output Impedance: 600 Ω
@ 1 kHz
Signal-To-Noise Ratio ^[1]: 72 dB
@ 1 kHz
Maximum SPL ^[1]: 139.0 dB
1000 Ω load, @ 1% THD
Dynamic Range ^[1]: 117.0 dB
@ 1 kHz, 1000 Ω load
Equivalent Output Noise ^[1]: 22 dB
Typical, A-Weighted
Power Requirements: +5 V DC (nominal), 10 V maximum (DC bias)
Polarity: Positive pressure on diaphragm produces positive voltage on pin 3 with respect to pin 1
Cable: 1.3 m (50 in.)
Connector: TA4F
Frequency Repsonse Curve:

^[1]Measurements taken using RK100PK preamp set @ 0 dB using 8k bias resistor.
* All specifications measured with a 48 VDC phantom power supply. The microphone operates at lower voltages, but with slightly decreased headroom and sensitivity.